ICOM-F5330D IC-F6330D Space Saving, Flexible Installation PoE Remote-Control Mobile Radio

VHF/IDAS DIGITAL——IC-F5330D

UHF/IDAS DIGITAL——IC-F6330D

• Flexible Installation Using an Ethernet Cable Between the Main Unit and Commandmic™

• Loud and Intelligible Audio Even in Noisy Environment

• Input /Output Interface for External Devices with Optional D-SUB Accessory Cable

• Dual Mode Operation – IDAS™ Digital Mode and Analogue FM Mode

• 400 – 520 MHz Wide Frequency Coverage (IC-F6330D UHF version)

• General Features

1. 136–174, 400–520 MHz versions
2. 128 Channels / 8 Zones
3. Two-piece configuration – Commandmic™ + black box main unit
4. Commandmic™ is powered from the main unit through an Ethernet cable*
   * Extendable up to 100m, 328 ft. (Cat 5e LAN cable user supplied).
5. High contrast, wide viewing angle, black background display on the Commandmic™
6. 1700 mW (typical) audio output from the Commandmic™
7. MIL-STD-810 G shock, vibration, temperature and more
8. IPX4 water splash resistance for the Commandmic™
9. DTMF autodial memories capability

• Operating Mode

1. NXDN™ conventional
2. NXDN™ Type-D single-site trunking
3. NXDN™ simulcast
4. NXDN™ multi-site conventional over IP network
5. Analogue mode

• Digital Functions (Voice and Data)

1. PTT ID and ANI
2. Over-the-Air Alias (OAA) displays the caller’s name without programming
3. Individual, Group and All call
4. Late entry for Group call
5. Status call and Polling call
6. Short data messages
7. Call alert
8. Radio check (RX only)

• Analogue Functions

1. CTCSS and DTCS tone
2. 2-Tone and 5-Tone
3. MDC functions; PTT ID, Emergency (TX/RX), Radio check (RX), Stun (RX), Revive (RX)
4. BIIS PTT ID transmission

• Security and Safety

1. Digital voice scrambler
2. Emergency call and Lone worker
3. Remote monitor (RX)
4. Radio Kill, Stun and Revive (RX)

• Scan Functions

1. Priority scan monitors one or two priority channels while scanning non-priority channels
2. Voting scan automatically selects the optimal repeater site

• Hardware Features

1. Set an IP address for main unit and Commandmic™
2. GPS receiver connection with optional ACC cable
3. Optional D-SUB connector, OPC-2078/OPC-1939, for external PTT, channel, horn, ignition switch, and dimmer control, according to programming

• Flexible Installation with a PoE Switch and IP Network

Using a PoE (Power over Ethernet) switch (as the power supply to the microphone) and an IP network, you can easily install the IC-F5330D series into a building*. In this installation scenario, you don’t have to worry about the distance between the main unit and the Commandmic™. Also, as the main (RF) unit can be installed close to the antenna, cable loss is kept to a minimum.